Siemens TC63 manual Roprstr+CSCS

TC63 AT Command Set

2.14 AT^SCFG

s

<ropr>(str)(+CSCS)

Radio Output Power Reduction

According to 3GPP Rel99, output power reduction for multiple TX slots is a mandatory feature. The amount of power reduction is configurable up to 3.0dB for 2TX, 4.8dB for 3Tx to 6dB for 4TX. To optimize heat dissipation, power consumption and SAR values it is recommended to use full power reduction (value "3").

Parameter is global for all interfaces, volatile and will not be reset by AT&F.

“1“	Medium Reduction at GMSK (0dB for 1TX and 2TX, 1.8dB for 3TX and 3dB
	reduction 4TX
“2“	Medium Reduction at GMSK (1TX 0dB, 2TX 3dB, 3TX 4.8dB and 4TX 6dB
	reduction)
“3“(P)	Maximal Reduction at GMSK (1TX 0dB, 2TX 3dB, 3TX 4.8dB and 4TX 6dB
	reduction)
<succ>(str)(+CSCS)
CIEV Call Status Indication

This parameter can be used to control the behaviour of URC "+CIEV: call". See also AT+CIND, AT+CMER and Section 7.1, Call Status Information.

Parameter is global for all interfaces and will not be reset by AT&F.

“restricted“(P)	URC "+CIEV: call" will be issued only when a Call Status transition ends in
	state "active" or "unknown" (see Section 7.1, Call Status Information) for a call
	in the list of active calls.
“verbose“	URC "+CIEV: call" will be issued when any state transition (including transi-
	tions beginning or ending in state "unknown") occurs in the list of active calls,
	or when a traffic channel is established.
<sucs>(str)(+CSCS)
SLCC Call Status Indication

This parameter can be used to control the behaviour of URC "^SLCC". See also AT^SLCC and Section 7.1, Call Status Information.

Parameter is global for all interfaces and will not be reset by AT&F.

“restricted“	URC "^SLCC" will be issued only when a Call Status transition ends in state
	"active" or "unknown" (see Section 7.1, Call Status Information) for a call in the
	list of active calls
“verbose“(P)	URC "^SLCC" will be issued when any state transition (including transitions
	beginning or ending in state "unknown") occurs in the list of active calls, or
	when a traffic channel is established.
<uri>(str)(+CSCS)
URC RING line

This parameter can be used to control the behaviour of the RING line to indicate URCs (both for idle interfaces and, if configured by the parameter "URC/Datamode/Ringline", if link is reserved) and, if configured, the indicator for incoming IP packets (see parameter "GPRS/RingOnIncomingData" (<groid>).

Parameter is local for the interface, volatile and will not be reset by AT&F.

“off“	URC is not indicated by RING.
“local“(P)	URC will be indicated by an activated RING line of the interface on which the
	URC appears
“asc0“	URC is indicated by an activated RING0 line.

TC63_ATC_V00.490	Page 61 of 501	5/24/05
Confidential / Draft - Do not copy