TC63 AT Command Set

7.25 AT+CSNS

s

7.25AT+CSNS Single Numbering Scheme

Syntax

Test Command

AT+CSNS=?

Response(s)

+CSNS: (list of supported<mode>s)

OK

Read Command

AT+CSNS?

Response(s)

+CSNS: <mode>

OK

Write Command

AT+CSNS=[<mode>]

Response(s)

OK ERROR +CME ERROR

Reference(s)

GSM 07.07

PIN ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge 4 Last

! % % % % % % ! % !

Command Description

The AT+CSNS command enables the ME to accept incoming calls when no bearer capability information is pro- vided with the call, e.g. single numbering scheme calls or calls originitating from analog devices.

Parameter Description

<mode>(num)

[0](D)

Voice: Each call received without bearer element is assumed to be speech

2

Fax: Each call received withoutbearer element is assumed to be an incoming

 

fax.

4

Data: Each call received without bearer element is assumed to be a data call.

 

Please take into account that the bearer service parameters set with AT+CBST

 

apply to all data calls including those received without bearer capability.

Notes

The command must be set before the call comes. By default, when you do not modify the settings, all calls received without bearer element are assumed to be voice.

The setting will be automatically saved when you power down the GSM engine with AT^SMSO, provided that PIN authentication has been done. This value will be restored when PIN authentication is done again.

TC63_ATC_V00.490

Page 174 of 501

5/24/05

Confidential / Draft - Do not copy

 

 

Page 174
Image 174
Siemens TC63 manual 25 AT+CSNS Single Numbering Scheme, At+Csns=?, At+Csns?, +CSNS mode, AT+CSNS=mode