SMC Networks SMC6724L3 manual IP Routing Commands, Interface Configuration Vlan

IP ROUTING COMMANDS

Command Mode

Interface Configuration (VLAN)

Command Usage

Proxy ARP allows a non-routing device to determine the MAC address of a host on another subnet or network.

Example

Console(config)#interface vlan 3

Console(config-if)#ip proxy-arp

Console(config-if)#

IP Routing Commands

After you configure network interfaces for this router, you must set the paths used to send traffic between different interfaces. If you enable routing on this device, traffic will automatically be forwarded between all of the local subnetworks. However, to forward traffic to devices on other subnetworks, you can either configure fixed paths with static routing commands, or enable a dynamic routing protocol that exchanges information with other routers on the network to automatically determine the best path to any subnetwork.

This section includes commands for both static and dynamic routing. These commands are used to connect between different local subnetworks or to connect the router to the enterprise network.

Command Group	Function	Page
Global Routing	Configures global parameters for static and dynamic	4-226
Configuration	routing, displays the routing table, and statistics for
	protocols used to exchange routing information
Routing	Configures global and interface specific parameters for	4-231
Information	RIP
Protocol (RIP)
Open Shortest	Configures global and interface specific parameters for	4-244
Path First (OSPF)	OSPF

4-225