SMC Networks SMC6724L3 manual Ip route, No static routes are configured

IP ROUTING COMMANDS

ip route

Use this command to configure static routes. Use the no form to remove static routes.

Syntax

ip route {destination-ip netmask default} {gateway} [metric metric] no ip route {destination-ip netmask default *}

•destination-ip– IP address of the destination network, subnetwork, or host.

•netmask - Network mask for the associated IP subnet. This mask identifies the host address bits used for routing to specific subnets.

•default – Sets this entry as the default route.

•gateway – IP address of the gateway used for this route.

•metric – Selected RIP cost for this interface. (Range: 1-5, default: 1)

•* – Removes all static routing table entries.

Default Setting

No static routes are configured.

Command Mode

Global Configuration

Command Usage

•You can configure up to 2000 static routes.

•Static routes take precedence over dynamically learned routes.

•Static routes are included in RIP updates periodically sent by the router.

Example

This example forwards all traffic for subnet 192.168.1.0 to the router 192.168.5.254, using the default metric of 1.

Console(config)#ip route 192.168.1.0 255.255.255.0 192.168.5.254 Console(config)#

4-227