SMC Networks SMC6724L3 manual IP Interface Commands, Basic IP Configuration

IP INTERFACE COMMANDS

IP Interface Commands

There are no IP addresses assigned to this router by default. You must manually configure a new address to manage the router over your network or to connect the router to existing IP subnets. You may also need to a establish a default gateway between this device and management stations or other devices that exist on another network segment (if routing is not enabled).

This section includes commands for configuring IP interfaces, the Address Resolution Protocol (ARP) and Proxy ARP. These commands are used to connect subnetworks to the enterprise network.

Command Group	Function	Page
Basic IP	Configures the IP address for interfaces and the	4-215
Configuration	gateway router
Address Resolution	Configures static, dynamic and proxy ARP service	4-221
Protocol (ARP)

Basic IP Configuration

Command	Function	Mode	Page
ip address	Sets the IP address for the current interface	IC	4-216
ip default-gateway	Defines the default gateway through which this	GC	4-218
	router can reach other subnetworks
show ip interface	Displays the IP settings for this device	PE	4-219
show ip redirects	Displays the default gateway configured for	PE	4-219
	this device
ping	Sends ICMP echo request packets to another	NE,	4-220
	node on the network	PE

4-215