SMC Networks SMC6724L3 manual Network 4-105 host, Network network-number mask no network

DHCP COMMANDS

Command Mode

Global Configuration

Usage Guidelines

•After executing this command, the switch changes to DHCP Pool Configuration mode, identified by the (config-dhcp)# prompt.

•From this mode, first configure address pools for the network interfaces (using the network command). You can also manually bind an address to a specific client (with the host command) if required. You can configure up to 8 network address pools, and up to 32 manually bound host address pools (i.e., listing one host address per pool). However, note that any address specified in a host command must fall within the range of a configured network address pool.

Example

Console(config)#ip dhcp pool R&D

Console(config-dhcp)#

Related Commands

network (4-105) host (4-113)

network

Use this command to configure the subnet number and mask for a DHCP address pool. Use the no form to remove the subnet number and mask.

Syntax

network network-number [mask] no network

•network-number- The IP address of the DHCP address pool.

•mask - The bit combination that identifies the network (or subnet) and the host portion of the DHCP address pool.

Command Mode

DHCP Pool Configuration

4-105