SMC Networks SMC6724L3 manual 238

COMMAND LINE INTERFACE

Default Setting

The default depends on the setting specified with the version command:

Global RIPv1 - Routes broadcast to other routers with RIPv2 Global RIPv2 - RIPv2 packets

Command Usage

•Use this command to override the global setting specified by the RIP version command.

•You can specify the receive version based on these options:

-Use “none” to passively monitor route information advertised by other routers attached to the network.

-Use “1” or “2” if all routers in the local network are based on RIPv1 or RIPv2, respectively.

-Use “v2-broadcast” to propagate route information by broadcasting to other routers on the network using RIPv2, instead of multicasting as normally required by RIPv2. (Using this mode allows RIPv1 routers to receive these protocol messages, but still allows RIPv2 routers to receive the additional information provided by RIPv2, including subnet mask, next hop and authentication information.)

Example

This example sets the interface version for VLAN 1 to send RIPv1 packets.

Console(config)#interface vlan 1

Console(config-if)#ip rip send version 1

Console(config-if)#

Related Commands

version (4-235)

4-238