SMC Networks SMC6724L3 manual 123, Negotiation 4-121speed-duplex4-120 flowcontrol

INTERFACE COMMANDS

•symmetric (Gigabit only) - When specified, the port transmits and receives pause frames; when not specified, the port will auto-negotiate to determine the sender and receiver for asymmetric pause frames. (The current switch ASIC only supports symmetric pause frames.)

Default Setting

•100BASE-TX: 10half, 10full, 100half, 100full

•1000BASE-T: 10half, 10full, 100half, 100full, 1000full

•1000BASE-SX/LX/LH: 1000full

Command Mode

Interface Configuration (Ethernet, Port Channel)

Command Usage

When auto-negotiation is enabled with the negotiation command, the switch will negotiate the best settings for a link based on the capabilites command. When auto-negotiation is disabled, you must manually specify the link attributes with the speed-duplexand flowcontrol commands.

Example

The following example configures Ethernet port 5 capabilities to 100half, 100full and flow control.

Console(config)#interface ethernet 1/5

Console(config-if)#capabilities 100half

Console(config-if)#capabilities 100full

Console(config-if)#capabilities flowcontrol

Console(config-if)#

Related Commands

negotiation (4-121)speed-duplex(4-120) flowcontrol (4-124)

4-123