SMC Networks SMC6724L3 manual Ip ospf transmit-delay, 270

COMMAND LINE INTERFACE

Command Usage

A router will resend an LSA to a neighbor if it receives no acknowledgment. The retransmit interval should be set to a conservative value that provides an adequate flow of routing information, but does not produce unnecessary protocol traffic. Note that this value should be larger for virtual links.

Example

Console(config)#interface vlan 1

Console(config-if)#ip ospf retransmit-interval 7

Console(config-if)#

ip ospf transmit-delay

Use this command to set the estimated time to send a link-state update packet over an interface. Use the no form to restore the default value.

Syntax

ip ospf transmit-delay seconds no ip ospf transmit-delay

seconds - Sets the estimated time required to send a link-state update. (Range: 1-65535)

Command Mode

Interface Configuration (VLAN)

Default Setting

1 second

Command Usage

LSAs have their age incremented by this delay before transmission. When estimating the transmit delay, consider both the transmission and propagation delays for an interface. Set the transmit delay according to link speed, using larger values for lower-speed links. The transmit delay must be the same for all routers attached to an autonomous system.

Example

Console(config)#interface vlan 1

Console(config-if)#ip ospf transmit-delay 6

Console(config-if)#

4-270