SMC Networks SMC6724L3 manual 100

CONFIGURING THE SWITCH

-Forwarding - Port forwards packets, and continues learning addresses.

•Trunk – Indicates if a port is a member of a trunk. (STA Port Configuration only)

The following interface attributes can be configured:

•Priority – Defines the priority used for this port in the Spanning Tree Protocol. If the path cost for all ports on a switch are the same, the port with the highest priority (i.e., lowest value) will be configured as an active link in the Spanning Tree. This makes a port with higher priority less likely to be blocked if the Spanning Tree Protocol is detecting network loops. Where more than one port is assigned the highest priority, the port with lowest numeric identifier will be enabled.

Default: 128

Range: 0-240, in steps of 16

•Path Cost – This parameter is used by the STP to determine the best path between devices. Therefore, lower values should be assigned to ports attached to faster media, and higher values assigned to ports with slower media. (Path cost takes precedence over port priority.) Note that when the Path Cost Method is set to short (page 3-63), the maximum path cost is 65,535.

•Range –

-Ethernet: 200,000-20,000,000

-Fast Ethernet: 20,000-2,000,000

-Gigabit Ethernet: 2,000-200,000

•Default –

-Ethernet – Half duplex: 2,000,000; full duplex: 1,000,000; trunk: 500,000

-Fast Ethernet – Half duplex: 200,000; full duplex: 100,000; trunk: 50,000

-Gigabit Ethernet – Full duplex: 10,000; trunk: 5,000

3-100