SMC Networks SMC6724L3 manual 179, Configuring Network Interfaces for RIP

IP ROUTING

Web - Click Routing Protocol, RIP, Network Addresses. Add all interfaces that will participate in RIP, and click Apply.

CLI - This example includes network interface 10.1.0.0 in the RIP routing process.

Console(config)#router-rip				4-231
Console(config-router)#network 10.1.0.0				4-233
Console(config-router)#end
Console#show ip	rip status			4-242
Peer	UpdateTime	Version	RcvBadPackets	RcvBadRoutes
---------------	------------ --------- --------------- --------------
10.1.0.253		0	0	73
10.1.1.253		0	0	66

Console#

Configuring Network Interfaces for RIP

For each interface that participates in the RIP routing process, you must specify the protocol message type accepted (i.e., RIP version) and the message type sent (i.e., RIP version or compatibility mode), the method for preventing loopback of protocol messages, and whether or not authentication is used (i.e., authentication only applies if RIPv2 messages are being sent or received).

3-179