SMC Networks SMC6724L3 manual Area default-cost, 252, Default Setting Command Usage, Area stub

COMMAND LINE INTERFACE

area default-cost

Use this command to specify a cost for the default summary route sent into a stub or not-so-stubby area (NSSA) from an Area Border Router (ABR). Use the no form to remove the assigned default cost.

Syntax

area area-iddefault-cost cost no area area-iddefault-cost

•area-id- Identifier for a stub or NSSA, in the form of an IP address.

•cost - Cost for the default summary route sent to a stub or NSSA. (Range: 0-65535)

Command Mode

Router Configuration

Default Setting

1

Command Usage

•If you enter this command for a normal area, it will changed to a stub.

•If the default cost is set to “0,” the router will not advertise a default route into the attached stub or NSSA.

Example

Console(config-router)#area 10.3.9.0 default-cost 10

Console(config-router)#

Related Commands

area stub (4-257)

4-252