SMC Networks SMC6724L3 manual Enabling Snmp Management Access, Community Strings

BASIC CONFIGURATION

6.Then save your configuration changes by typing “copy running-config startup-config.” Enter the startup file name and press <Enter>.

Console(config)#interface vlan 1 Console(config-if)#ip address dhcp Console(config-if)#end Console#ip dhcp restart client Console#show ip interface

Vlan 1 is up, addressing mode is DHCP

Interface address is 10.1.0.54, mask is 255.255.255.0, Primary MTU is 1500 bytes

Proxy ARP is disabled Split horizon is enabled

Console#copy running-config startup-config Startup configuration file name []: startup \Write to FLASH Programming.

\Write to FLASH finish. Success.

Enabling SNMP Management Access

The switch can be configured to accept management commands from Simple Network Management Protocol (SNMP) applications such as HP OpenView. You can configure the switch to (1) respond to SNMP requests or (2) generate SNMP traps.

When SNMP management stations send requests to the switch (either to return information or to set a parameter), the switch provides the requested data or sets the specified parameter. The switch can also be configured to send information to SNMP managers (without being requested by the managers) through trap messages, which inform the manager that certain events have occurred.

Community Strings

Community strings are used to control management access to SNMP stations, as well as to authorize SNMP stations to receive trap messages from the switch. You therefore need to assign community strings to specified users or user groups, and set the access level.

2-9