SMC Networks SMC6724L3 manual Ip pim hello-interval, 304

COMMAND LINE INTERFACE

Example

Console(config)#interface vlan 1 Console(config-if)#ip pim dense-mode Console#show ip pim interface

Vlan 1 is up

PIM is enabled, mode is Dense. Internet address is 10.1.0.253.

Hello time interval is 30 sec, trigger hello time interval is 5 sec. Hello holdtime is 105 sec.

Join/Prune holdtime is 210 sec.

Graft retry interval is 3 sec, max graft retries is 2. DR Internet address is 10.1.0.253, neighbor count is 0.

Console#

ip pim hello-interval

Use this command to configure the frequency at which PIM hello messages are transmitted. Use the no form to restore the default value.

Syntax

ip pim hello-interval seconds no pim hello-interval

seconds - Interval between sending PIM hello messages. (Range: 1-65535)

Default Setting

30 seconds

Command Mode

Interface Configuration (VLAN)

Command Usage

Hello messages are sent to neighboring PIM routers from which this device has received probes, and are used to verify whether or not these neighbors are still active members of the multicast tree.

Example

Console(config-if)#ip pim hello-interval 60

Console(config-if)#

4-304