SMC Networks TigerSwitch 100 manual 110, Parameter Description

Models: TigerSwitch 100

1 334
Download 334 pages 51.76 Kb
Page 140
Image 140

CONFIGURING THE SWITCH

Parameter

Description

 

 

Transmit Octets

The total number of octets transmitted out of the

 

interface, including framing characters.

 

 

Transmit Unicast Packets

The total number of packets that higher-level

 

protocols requested be transmitted to a

 

subnetwork-unicast address, including those that were

 

discarded or not sent.

 

 

Transmit Multicast

The total number of packets that higher-level

Packets

protocols requested be transmitted, and which were

 

addressed to a multicast address at this sub-layer,

 

including those that were discarded or not sent.

 

 

Transmit Broadcast

The total number of packets that higher-level

Packets

protocols requested be transmitted, and which were

 

addressed to a broadcast address at this sub-layer,

 

including those that were discarded or not sent.

 

 

Transmit Discarded

The number of outbound packets which were chosen

Packets

to be discarded even though no errors had been

 

detected to prevent their being transmitted. One

 

possible reason for discarding such a packet could be

 

to free up buffer space.

 

 

Transmit Errors

The number of outbound packets that could not be

 

transmitted because of errors.

 

 

Etherlike Statistics

 

 

 

Alignment Errors

The number of alignment errors (missynchronized

 

data packets).

 

 

Late Collisions

The number of times that a collision is detected later

 

than 512 bit-times into the transmission of a packet.

 

 

FCS Errors

A count of frames received on a particular interface

 

that are an integral number of octets in length but do

 

not pass the FCS check. This count does not include

 

frames received with frame-too-long or

 

frame-too-short error.

 

 

Excessive Collisions

A count of frames for which transmission on a

 

particular interface fails due to excessive collisions.

 

This counter does not increment when the interface is

 

operating in full-duplex mode.

 

 

2-110

Page 140
Image 140
SMC Networks TigerSwitch 100 manual 110, Parameter Description