INTERFACE COMMANDS

capabilities

Use this command to advertise the port capabilities of a given interface during autonegotiation. Use the no form with parameters to remove an advertised capability, or the no form without parameters to restore the default values.

Syntax

capabilities {1000full 100full 100half 10full 10half flowcontrol symmetric}

no port-capabilities [1000full 100full 100half 10full 10half flowcontrol symmetric]

1000full - Supports 1000 Mbps full-duplex operation

100full - Supports 100 Mbps full-duplex operation

100half - Supports 100 Mbps half-duplex operation

10full - Supports 10 Mbps full-duplex operation

10half - Supports 10 Mbps half-duplex operation

flowcontrol - Supports flow control

symmetric (Gigabit only) - When specified, the port transmits and receives pause frames; when not specified, the port will auto-negotiate to determine the sender and receiver for asymmetric pause frames. (The current switch ASIC only supports symmetric pause frames.)- Transmits and receives pause frames for flow control

Default Setting

The default values for Gigabit Ethernet include all settings.

100BASE-TX: 10half, 10full, 100half, 100full

1000BASE-T: 10half, 10full, 100half, 100full, 1000full

1000BASE-SX/LX/LH: 1000full

Command Mode

Interface Configuration (Ethernet, Port Channel)

3-89

Page 233
Image 233
SMC Networks TigerSwitch 100 manual Capabilities, Default Setting