COMMAND LINE INTERFACE
Example
Console(config)#
Related Commands
snmp ip filter
Sets the IP addresses of clients that are allowed management access to the switch via SNMP. Use the no form of this command to remove an IP address.
Syntax
snmp ip filter ip_address subnet_mask no snmp ip filter ip_address subnet_mask
•ip_address - An IP address indicating a client or group of clients that are allowed SNMP access to the switch.
•subnet_mask - An address bitmask of decimal numbers that represent the address bits to match.
Default Setting
None
Command Mode
Global Configuration
Command Usage
•You can create a list of up to 16 IP addresses or IP address groups that are allowed access to the switch via SNMP management software.
•Address bitmasks are similar to a subnet mask, containing four decimal integers from 0 to 255, each separated by a period. The binary mask uses “1” bits to indicate “match” and “0” bits to indicate “ignore.”
•If the IP is the address of a single management station, the bitmask should be set to 255.255.255.255. Otherwise, the IP address group is
