SMC Networks TigerSwitch 100 manual Snmp Commands, Snmp-server community

COMMAND LINE INTERFACE

Example

Console#show tacacs-server

Remote TACACS server configuration:

Server IP address: 10.11.12.13

Communication key with radius server:

Server port number: 49

Console#

SNMP Commands

Controls access to this switch from SNMP management stations, as well as the error types sent to trap managers.

Command	Function	Mode	Page
snmp-server	Sets up the community access string to	GC	3-58
community	permit access to SNMP commands
snmp-server contact	Sets the system contact string	GC	3-60
snmp-server location	Sets the system location string	GC	3-60
snmp-server host	Specifies the recipient of an SNMP	GC	3-61
	notification operation
snmp-server enable	Enables the device to send SNMP	GC	3-63
traps	notifications (i.e., SNMP traps)
snmp ip filter	Sets IP addresses of clients allowed to	GC	3-64
	management access to the switch via
	SNMP
show snmp	Displays the status of SNMP	NE,	3-65
	communications	PE

snmp-server community

Use this command to define the community access string for the Simple Network Management Protocol. Use the no form to remove the specified community string.

3-58