
ADDRESS TABLE SETTINGS
CLI Configuration
Use the interface command to select the target port, then use the port security action command to configure the port intrusion action (applies to all ports). Use the port security command to enable security for the port.
Console(config)#interface ethernet 1/5 |
|
| |
| |
|
|
Address Table Settings
Switches store the addresses for all known devices. This information is used to route traffic directly between the inbound and outbound ports. All the addresses learned by monitoring traffic are stored in the dynamic address table. You can also manually configure static addresses that are bound to a specific port.
Setting Static Addresses
A static address can be assigned to a specific interface on this switch. Static addresses are bound to the assigned interface and will not be moved. When a static address is seen on another interface, the address will be ignored and will not be written to the address table.