SMC Networks TigerSwitch 100 manual Host Address None Snmp Version

COMMAND LINE INTERFACE

Default Setting

Host Address: None

SNMP Version: 1

Command Mode

Global Configuration

Command Usage

•If you do not enter an snmp-server host command, no notifications are sent. In order to configure the switch to send SNMP notifications, you must enter at least one snmp-server host command. In order to enable multiple hosts, you must issue a separate snmp-server host command for each host.

•The snmp-server host command is used in conjunction with the snmp-server enable traps command. Use the snmp-server enable traps command to specify which SNMP notifications are sent globally. For a host to receive notifications, at least one snmp-server enable traps command and the snmp-server host command for that host must be enabled.

•The switch can send SNMP version 1 or version 2c traps to a host IP address, depending on the SNMP version that the management station supports. If the snmp-server host command does not specify the SNMP version, the default is to send SNMP version 1 traps.

•Some notification types cannot be controlled with the snmp-server enable traps command. For example, some notification types are always enabled.

Example

Console(config)#snmp-server host 10.1.19.23 batman

Console(config)#

Related Commands

snmp-server enable traps (3-63)

3-62