SMC Networks TigerSwitch 100 manual 168, Syntax Lacp no lacp Default Setting

COMMAND LINE INTERFACE

Example

The following example creates trunk 1 and then adds port 11:

Console(config)#interface port-channel 1

Console(config-if)#exit

Console(config)#interface ethernet 1/11

Console(config-if)#channel-group 1

Console(config-if)#

lacp

Use this command to enable 802.3ad Link Aggregation Control Protocol (LACP) for the current interface. Use the no form to disable it.

Syntax

lacp no lacp

Default Setting

Disabled

Command Mode

Interface Configuration (Ethernet)

Command Usage

•The ports on both ends of an LACP trunk must be configured for full duplex, either by forced mode or auto-negotiation.

•A trunk formed with another switch using LACP will automatically be assigned the next available port-channel ID.

•If the target switch has also enabled LACP on the connected ports, the trunk will be activated automatically.

•If more than four ports attached to the same target switch have LACP enabled, the additional ports will be placed in standby mode, and will only be enabled if one of the active links fails.

3-168