SMC Networks TigerSwitch 100 manual Spanning-tree portfast, 115

SPANNING TREE COMMANDS

Related Commands

spanning-tree cost (3-113)

spanning-tree portfast

Use this command to set an interface to fast forwarding. Use the no form to disable fast forwarding.

Syntax

spanning-tree portfast no spanning-tree portfast

Default Setting

Disabled

Command Mode

Interface Configuration (Ethernet, Port Channel)

Command Usage

•This command is used to enable/disable the fast Spanning Tree mode for the selected interface. In this mode, interfaces skip the Learning state and proceed straight to Forwarding.

•Since end-nodes cannot cause forwarding loops, they can be passed through the spanning tree state changes more quickly than allowed by standard convergence time. Fast forwarding can achieve quicker convergence for end-node workstations and servers, and also overcome other STP related timeout problems. (Remember that fast forwarding should only be enabled for ports connected to a LAN segment that is at the end of a bridged LAN or for an end-node device.)

•This command is the same as spanning-tree edge-port, and is only included for backward compatibility with earlier products. Note that this command may be removed for future software versions.

Example

Console(config)#interface ethernet 1/5

Console(config-if)#spanning-tree portfast

Console(config-if)#

3-115