IP COMMANDS
IP Commands
An IP address may be used for management access to the switch over your network. By default, the switch uses DHCP to assign IP settings to VLAN 1 on the switch. If you wish to manually configure IP settings, you need to change the switch’s
Command | Function | Mode | Page |
ip address | Sets the IP address for this device | IC | |
|
|
|
|
ip dhcp restart | Submits a BOOTP or DCHP client request | PE | |
|
|
|
|
ip | Defines the default gateway through which an | GC | |
|
| ||
| device |
|
|
|
|
|
|
show ip interface | Displays the IP settings for this device | PE | |
|
|
|
|
show ip redirects | Displays the default gateway configured for | PE | |
| this device |
|
|
|
|
|
|
ping | Sends ICMP echo request packets to another | NE, | |
| node on the network | PE |
|
|
|
|
|
ip address
Use this command to set the IP address for this device. Use the no form to restore the default IP address.
Syntax
ip address
•
•netmask - Network mask for the associated IP subnet. This mask identifies the host address bits used for routing to specific subnets.
•bootp - Obtains IP address from BOOTP.