SMC Networks TigerSwitch 100 manual Syntax Spanning-tree no spanning-tree Default Setting

COMMAND LINE INTERFACE

spanning-tree

Use this command to enable the Spanning Tree Protocol globally for this switch. Use the no form to disable it.

Syntax

spanning-tree no spanning-tree

Default Setting

Spanning Tree is enabled.

Command Mode

Global Configuration

Command Usage

The Spanning Tree Protocol can be used to detect and disable network loops, and to provide backup links between switches, bridges or routers. This allows the switch to interact with other bridging devices (that is, an STP-compliant switch, bridge or router) in your network to ensure that only one route exists between any two stations on the network, and provide backup links which automatically take over when a primary link goes down.

Example

The following example enables the Spanning Tree Protocol for this switch:

Console(config)#spanning-tree

Console(config)#

3-106