CONFIGURING THE SWITCH
Port Security Action
The switch allows you to set the security action to be taken when a port intrusion is detected. This setting applies to all ports on the switch.
•Shutdown and Trap — Indicates the action to be taken when a port security violation is detected:
-None: Indicates that no action should be taken. (This is the default.)
-Trap and Shutdown: Indicates that the port is to be disabled and an SNMP trap message sent.
Web – Click Port, Port Security Action. Specify the security action for a port intrusion, then click Apply.
Port Security Configuration
On the Port, Port Security Status page, you can enable/disable security for any switch port. For each port number listed in the “Port” column, you can configure the following parameter:
•Security Status — Enables or disables port security on the port. (Default: disabled)
Note: If a port is disabled due to a security violation, it must be manually
Web – Click Port, Port Security Status. Check the checkbox in the “Security Status” column to enable security for a port, then click Apply.
