SMC Networks TigerSwitch 100 manual System Defaults, Function Parameter Default

SYSTEM DEFAULTS

In the system flash memory, one file of each type must be set as the start-up file. During a system boot, the diagnostic and operation code files set as the start-up file are run, and then the start-up configuration file is loaded.

System Defaults

The switch’s system defaults are provided in the configuration file “Factory_Default_Config.cfg.” To reset the switch defaults, this file should be set as the startup configuration file. See “Saving or Restoring Configuration Settings” on page 2-24.

The following table lists some of the basic system defaults.

Function	Parameter	Default
IP Settings	Management VLAN	1
	DHCP	Enabled
	BOOTP	Disabled
	User Specified	Disabled
	IP Address	0.0.0.0
	Subnet Mask	255.0.0.0
	Default Gateway	0.0.0.0
Web Management	HTTP Server	Enabled
	HTTP Port Number	80
SNMP	Community Strings	“public” (read only)
		“private” (read/write)
	Authentication Failure	Enabled
	Traps
	Link-up-Down Traps	Enabled

1-13