SMC Networks TigerSwitch 100 manual Port security

INTERFACE COMMANDS

Command Usage

•When broadcast traffic exceeds the specified threshold, packets above that threshold are dropped.

•This command can enable or disable broadcast storm control for the selected interface. However, the specified threshold value applies to all ports on the switch.

•Enabling jumbo frames for the switch will limit the maximum threshold for broadcast storm control to 64 packets per second.

Example

The following shows how to configure broadcast storm control at 64 packets per second on port 5:

Console(config)#interface ethernet 1/5

Console(config-if)#switchport broadcast packet-rate 64

Console(config-if)#

port security

Use this command to enable and configure port security on a port. Use the no form to disable port security or reset the intrusion action to the default.

Syntax

port security [action trap-and-shutdown]no port security [action]

action - Indicates the security action to be taken when a port security violation is detected (applies globally to all ports).

trap-and-shutdown- Issue an SNMP trap message and disable the port.

Default Setting

Status: Disabled

Action: None

Command Mode

Interface Configuration (Ethernet)

3-93