Toshiba HWS-1402XWHT6-E, HWS-802XWHT6-E Hot Water Boost Setting, Nighttime Low-noise Setting, 116

10. Hot Water Boost Setting

This setting heats the water whenever necessary by using the heat pump and hot water cylinder heater.

1 Press the HOT WATER button to start a hot water supply operation.

(Normal hot water supply operation)

2 Pressing the HOT WATER BOOST button displays the symbol. (See display )

(The set temperature does not change) The hot water supply operation of 75°C starts.

HOT WATER BOOST operation with the heat pump and heater ends when the water temperature reaches 75°C; however, the normal hot water supply operation automatically starts after 60 minutes even if the temperature is not as high as 75°C.

3 Pressing the HOT WATER BOOST		button again makes	2,3 1
	disappear, and the HOT WATER BOOST ends.

<How to set HOT WATER BOOST operation time and temperature>

In FC_08 or 09 (See 2-2), the operation time and set temperature can be changed. FC_08: Operation time change range 30 to 120 minutes (60 minutes: default) FC_09: Set temperature change range 40 to 80°C (75°C: default)

11. Nighttime Low-noise Setting

•This setting is used to reduce noise output, from the outdoor unit, during nighttime for neighbours. Nighttime low-noise operates with lower operation frequency and fan tap than usual only for the set time period.

•The operation is the same as usual hot water supply, heating, or cooling.

•Adjust the unit time before making the settings.

3,

5

<How to enable, set start time and end time of nighttime low-						2,
noise>
1	Press the TEST		and TEMP.	button at the same		4,
	time for 4 seconds or longer. (See display				)	6
	(Moves to the nighttime low-noise setting mode)					1
	"09" displayed in the Code No. field and the DATA currently
	displayed,	, and	blink.			4,6	7
2	Press TIME		to set enabled "1" or disabled "0".

Pressing SET changes DATA and indication to be lit and the setting is confirmed. (For DATA, only 1 or 0 can be selected.)

3	Press the TEMP.	button to change Code No. to "0A". DATA and			indication again
	blink.
4	Press the TIME	button to set start time. Pressing SET		changes DATA and
	indication to be lit and the setting is confirmed.
5	Press the TEMP.	button to change Code No. to "0B". DATA and			indication again
	blink.
6	Press the TIME	button to set end time. Pressing SET	changes DATA and
	indication to be lit and the setting is confirmed.
7	Press TEST	to exit the nighttime low-noise time setting mode.		and	indications go
	out.

116