Toshiba HWS-1402XWHT6-E Outdoor Unit 2-1. HWS-802H-E, Exchange parts, Work procedure, Remarks

2.Outdoor Unit 2-1. HWS-802H-E

No.	Exchange parts	Work procedure	Remarks
	name
1 Common procedure		Note	Front panel
		Wear gloves when performing the work.
		Failure to do so may cause an injury when
		accidentally contacting the parts.

1.How to remove

1)Stop the operation by remote controller and turn off the breaker.

2)Remove the front panel. (Hex Ø4 × 10, 2 screws)

•After unscrewing the screws, remove the front panel while pulling it downward.

3)Disconnect the power source cable and
connecting cables between hydro and outdoor
from the cord plank and terminals.	Top board
4)Remove the top board.
(Hex Ø4 × 10, 5 screws)

2.How to attach

1)Attach the top board. (Hex Ø4 × 10, 5 screws)

At this time, insert the back side fin guard between the top board and the water heat exchanger (back side).

2)Connect the power source cable and connecting cables between indoor and outdoor to the terminal, and fix them with the cord clamp.

Note	Insert the back side fin guard
	between the top board and the
The power source cable and connecting cable
	heat exchanger (back side).
between hydro and outdoor units must be fixed
along the connecting piping by using a cable tie
so that the cables do not contact the
compressor, gas side valve, gas side piping and
outlet pipe.
3)Attach the front panel.
(Hex Ø4 × 10, 2 screws)

136