Toshiba HWS-802XWHM3-E, HWS-802XWHT6-E, HWS-802H-E, HWS-3001CSHM3-E(-UK) 151, Compressor nut 3 nuts

No.	Exchange parts	Work procedure			Remarks
	name
6 Compressor		1. Remove defective compressor	Piping panel (Front)
	Compressor lead	1)Perform refrigerant gas recovery.
		2)Perform the step 1-1 and step 3.
		3) Remove the piping panel (Front).
		Remove screws of the piping panel (Front) and
		bottom board.
		(Hex Ø4 × 10, 2 screws)
		Remove screws of the piping panel (Front and			Piping panel (Back)
		Back).
					Piping cover	TD sensor
		(Hex Ø4 × 10, 1 screws)
			Binding tie
		4)Remove the piping panel (Back).
		Remove screws of the piping panel (Back) and	(for heat resistance)
		bottom board.
		(Hex Ø4 × 10, 2 screws)	Compressor lead
		5)Remove the soundproofing board. (Upper, Inward
		winding, Outward winding)
		6)Remove the compressor terminal cover, and then
		remove the compressor lead and compressor
		case thermostat.			Compressor case thermostat
		7)Remove the TD sensor fixed to the discharge	Control board
		piping.
		8)Remove the compressor lead. (Leave the ferrite
		core attached to the electric parts box.)
		Control board U: CN200 Red
		V: CN201 White
		W: CN202 Black
		9)Remove the outlet and suction pipes connected to			Compressor lead
		the compressor by using a burner.
		WARNING	Compressor lead
		When removing the piping by burning the solder,
		take enough care for a fire going off at the
		moment the wax melts if oil remains inside the
		piping.
		Note)
		Do not make fire flame contact with the 4-way
		valve and pulse motor valve.
		(This may cause an operation failure.)
		10) Pull out the discharge and suction pipes of the		Ferrite core
		refrigerant cycle upward.
		11) Remove the compressor nuts that fix the
			Remove
		compressor to the bottom board. (3 nuts)
			(Outlet pipe)
		12) Pull the compressor out toward you.
		Note)
		The compressor weighs 20 kg or more.
		Two people should be required to handle it.

Remove (Suction pipe)

450

Compressor nut (3 nuts)

151