Toshiba HWS-802XWHM3-E, HWS-802XWHT6-E, HWS-802H-E, HWS-3001CSHM3-E(-UK) 141, CN202 Black

No.	Exchange parts	Work procedure					Remarks
	name
6 Compressor		1. Remove defective compressor
	Compressor lead	1)Perform refrigerant gas recovery.						Piping panel (Back)
		2)Perform the step 1-1 and step 2 and 3.
		3)Remove the piping panel (Front).
		Remove screws of the piping panel (Front) and
		bottom board.
		(Hex Ø4 × 10, 2 screws)	Piping panel (Front)
		Remove screws of the piping panel (Front and
			Binding tie for
		Back).								Pipe cover
			heat resistance
		(Hex Ø4 × 10, 1 screw)
		4)Remove the piping panel (Back).	TD sensor
		Remove screws of the piping panel (Back) and
		bottom board.
		(Hex Ø4 × 10, 2 screws)
		5)Remove the valve fixing board.	Compressor lead
		Remove the bolt of the valve.
		(Hex head bolt Ø6 × 15, 4 bolts)
		Remove the screws of the valve fixing board and
		parting board.
		(ST1T Ø4 × 8, 1 screw)							Compressor case
		Remove the screws of the valve fixing board and							thermostat
		accumulator.
			TS sensor		Pipe cover, Binding tie
		(ST1T Ø4 × 8, 1 screw)
		Cut the binding tie of the discharge pipe and
		suction pipe to remove each sensor and the pulse
		motor valve coil lead.
		6)Remove the soundproofing board. (Upper, Inward
			Suction pipe							Outlet pipe
		winding, Outward winding)
		7)Remove the compressor terminal cover, and then
			Accumulator
		remove the compressor lead and compressor
		case thermostat.
		8)Remove the TD sensor fixed to the discharge pipe.
		9)Remove the compressor lead. (Leave the ferrite
		core attached to the electric parts box.)				Pipe cover, Binding tie
		Control board U: CN200 Red				Sensors (TL, TO, TE, TS)
		V: CN201 White				Motorized control valve coil lead
		W: CN202 Black		Black pipe cover for heat resistance,
		(Torque at tightening is 1.47		Binding tie for heat resistance
		±0.1N•m)		Sensors (TL, TO, TE, TD, TS)
				Motorized control valve coil lead

Control board

Compressor lead

Compressor lead

Ferrite core

141