Toshiba HWS-802H-E, HWS-802XWHT6-E 150, Fixing rubber Projection/Refrigerant cycle side Fan motor

No.	Exchange parts	Work procedure	Remarks
	name
5 Fan motor		1)Perform the step 1-1 and step 2.
		Propeller fan			Turn it right
		2)Remove the fan motor and the flange nut that fixes			to loosen
		the propeller fan.
		• To loosen the flange nut, turn it clockwise.
		(Turn it counterclockwise for tightening.)
		3)Remove the propeller fan.
		4)Remove the connector for fan motor from the			Flange nut
		inverter. (control board)
		(Remove the ferrite core of the lower fan motor to			Propeller fan
		use it again for a new fan motor.)
		5)Remove the fan motor lead from the fan motor
		lead fixing rubber on the through hole of the
		parting board.
		6)Remove the fixed screws (4 for each) while
		holding the fan motor so that it does not drop.
					Fan motor
		* Notes in assembling fan motor		Fan motor
		• Tighten the flange nut in 4.95 N•m (50kgf•cm).
				connector (upper)
		• To prevent the fan motor lead from contacting
		the propeller fan, adjust the length of fan motor
		lead fixing rubber so that it does not slack.
		Attach the fan motor lead fixing rubber to the
		parting board so that the projection part is		Fan motor
		placed on the refrigerant cycle side.
				connector (lower)
		• Make sure that the reactor body and the fan
		motor lead do not contact each other.
		• Be sure to bind the removed binding tie by
		using the commercially available binding tie.
		• Be sure to re-attach the ferrite core of the
				Fan motor ferrite
		lower fan motor. (Fix this with a commercially
				core (lower)
		available binding tie.)
				Fan motor lead
		Note		fixing rubber
		Fix the fan motor lead to the motor base using a
		metal tie so that the fan motor lead does not
		contact the propeller fan.
		Projection/Refrigerant
		cycle side
				Fan motor lead
				fixing rubber

Projection/Refrigerant cycle side

Fan motor

150