Toshiba VF-FS1 instruction manual Frequency priority selection, Setting of switching terminals

E6581381

■Setting of switching terminals

The terminal for switching to motor 2 needs to be set, since this function is not assigned under the default setting. Assign this function to an idle terminal.

The parameters to be switched depend on the particular identification number of the input terminal selection function.

		Input terminal function number				Parameters used and applicable parameters
	5		39	40	61
	AD2		VF2	MOT2	OCS2
	OFF		OFF	OFF	OFF	Default setting: RV, XN, XNX, XD, VJT, CEE,
						FGE, HU, H
	ON		OFF	OFF	OFF	CEE → HU, FGE → H,
						H → HU
	OFF		OFF	OFF	ON	H → H
	OFF		ON	OFF	OFF	RV → , XN → H, XNX → H,
						XD → H, VJT → H
						RV → , XN → H, XNX → H,
	-		-	ON	-	XD → H, VJT → H,
						H → H, CEE → HU,
6
						FGE → H, H → HU
	Note: The parameters XN, XNX, RV, H and H cannot be switched during operation. You need

to stop operation when switching them.

6.5Frequency priority selection

6.5.1Using a frequency command according to the particular situation

HOQF : Frequency setting mode selection 1

H : Frequency priority selection

H : Speed setting mode selection 2

•Function

These parameters are used to switch between two types of frequency command signals.

•Setting by parameters

•Switching by frequency

•Switching via terminal board input

F-14