
E6581381
H: Using this parameter along with H, adjust the speed of response to the frequency command.
H: Using this parameter along with H, adjust the speed of response to the frequency command.
*How to make adjustments according to the moment of inertia of the load
The moment of inertia of the load (including that of the motor shaft) was set at the factory on the assumption that it would be three times as large as that of the motor shaft.
Adjust H, H with the ratio of inertia in case load inertia is different from three times of the motor inertia.
When making the above adjustments, increase or decrease settings in steps of 10% or so while checking how things change.
Note also that, depending on the settings of H and H, the frequency may exceed the
6.15.2Setting motor constants 2 (Details)
6
H : Exciting current coefficient
H : Stall prevention control coefficient 1
H : Stall prevention control coefficient 2
H : Motor adjustment coefficient
H : Maximam voltage adjustment coefficient
H : Waveform switching adjustment coefficient
* The following parameters enables you to make adjustments more finely.
Title | Function | Adjustment range | Default setting | |
H | Exciting current coefficient | 100 | ||
H | Stall prevention control | 100 | ||
| coefficient 1 |
|
| |
H | Stall prevention control | 100 | ||
| coefficient 2 |
|
| |
H | Motor adjustment coefficient | Depends on | ||
the capacity | ||||
|
|
| ||
H | Maximam voltage adjustment | 104 | ||
| coefficient |
|
| |
H | Waveform switching | 14.0 | ||
| adjustment coefficient |
|
|
H: Used to fine adjust the magnetic field increase rate in
H: Using this parameter along with H adjusts characteristics in a region in which the frequency is above the base frequency (region where the field is weak).