E6581381
3.1Simplified Operation of the VF-FS1
The procedures for setting operation frequency and the methods of operation can be selected from the following.
Start / Stop
Setting the frequency
3
:(1) Run and stop from the operation panel
(2)Run and stop using external signals to the terminal board
(3)Run and stop through serial communication
:(1) Setting using the operation panel
(2)Setting using external signals to the terminal board
(3)Setting through serial communication
(4)Setting using external contact up/down
Local mode and Remote mode
LOC | Local mode : When Local mode selected by | LOC | key, start and stop, and frequency setting are |
REM | REM |
effective only by operation panel keys.
The LOC/REM key lamp is lit while Local mode selected.
Remote mode : Start and stop, and frequency setting follow the selection of EOQF(Command mode),or HOQF(Frequency setting mode).
*1 At default setting, the switching between Local mode and Remote mode is effective. When prohibiting this function, refer to the chapter 6.20.1.
*2 At default setting, when switched from remote of start or stop and running frequency at Remote mode are shifted to Local mode. When changing from Local mode to Remote mode, the inverter can start in case of running mode selection at remote side. In case of prohibiting this function. ⇒ See section 6.10.
*3 The status of Local/Remote mode is memoried when power off.
Remote mode selection, use the basic parameters EOQF (Command mode selection), HOQF (Frequency setting mode selection 1).
Title | Function | Adjustment range | Default setting | |
|
| 0: Terminal board |
| |
EOQF | Command mode selection | 1: Panel | 0 | |
|
| 2:Serial communication |
| |
|
| 1: VIA |
| |
| Frequency setting mode | 2: VIB |
| |
HOQF | 3: Operation panel | 1 | ||
selection 1 | ||||
| 4: Serial communication |
| ||
|
|
| ||
|
| 5: External contact up/down |
|
* See 5.3 for EOQF,HOQF.
