Cisco Systems 7500 Series manual Route Switch Processor Overview, RSP-Specific Hardware Features

Chapter 1 Cisco 7500 Series Product Overview

Route Switch Processor Overview

Route Switch Processor Overview

The main system processor in the Cisco 7500 series routers is the Route Switch Processor (RSP). The current RSP models sold are: RSP4+, RSP8 and RSP16.. The RSP1, RSP2 and RSP4 are legacy models. For more information on any of these products, refer to http://www.cisco.com/univercd/cc/td/doc/product/core/cis7505/rte_swit/index.htm for additional information on these models. The RSPs have common hardware features, and hardware features that differentiate one from the other.

The following sections first describe hardware features that are specific to each RSP model, and then describe features that are common to all RSPs.

RSP-Specific Hardware Features

The following sections describe hardware features that are specific to each of the RSPs used in the Cisco

7500 series. Select the appropriate section based on the RSP and Cisco 7500 series router that you have:

•RSP2—Cisco 7505, page 1-31

•RSP4/4+—Cisco 7507, Cisco 7513, and Cisco 7576, page 1-33

•RSP8—Cisco7507-MX and Cisco 7513-MX, page 1-36

•RSP16—Cisco 7507, Cisco 7507-MX, Cisco 7513, and Cisco 7513-MX, page 1-39

RSP2—Cisco 7505

The RSP2, shown in Figure 1-20, is the main system processor for the Cisco 7505 router, and provides switched routing and high-speed switching functions.

The RSP2 is installed in the top slot in the Cisco 7505, which is labeled Slot 4 on the backplane and RSP to the left of the slots. (See Figure 1-3.) An RSP4 can also be used in the Cisco 7505. (See the “RSP4/4+—Cisco 7507, Cisco 7513, and Cisco 7576” section on page 1-33.) An RSP8 can also be used in the Cisco 7505. (See the “RSP8—Cisco7507-MX and Cisco 7513-MX” section on page 1-36.)

	Cisco 7500 Series Installation and Configuration Guide
OL-5008-03 B0		1-31