Cisco Systems 7500 Series manual Installing the Card Cage Assembly

Chapter 7 Maintaining Your Cisco 7513, Cisco 7513-MX, and Cisco 7576 Router

Maintenance Procedures for the Cisco 7513, Cisco 7513-MX, and Cisco 7576

Installing the Card Cage Assembly

Use the following procedure to install the card cage assembly.

Caution The electronic components on the rear of the backplane are completely exposed when the card cage and backplane assembly is removed from the chassis. To prevent damaging these components, carefully slide the assembly into the chassis opening.

Figure 7-7 Installing the Card Cage Assembly

Captive screw

Card cage side flange

Captive screw

Air intake grill

POWER

A

POWER B

Captive screw

Card cage side flange

Captive screw

H8819

Step 1 Carefully lift the card cage assembly, place it into the chassis opening, and slide the assembly into the chassis opening until the left and right flanges on the card cage are flush with the chassis flanges.

Step 2 Squeeze the card cage and chassis flanges together, and tighten each captive screw. Do not overtighten the captive screws.

Step 3 Carefully replace the processor modules in the card cage. (See the procedure shown in Figure 3-14.)

Step 4 Reinstall the power supplies in the Cisco 7513, Cisco 7513-MX, or Cisco 7576. (See the “Installing Cisco 7513, Cisco 7513-MX, and Cisco 7576 Power Supplies” section on page 3-27.)

This completes the procedure for installing the card cage assembly in the Cisco 7513,

Cisco 7513-MX, and Cisco 7576.

Cisco 7500 Series Installation and Configuration Guide

OL-5008-03 B0 7-9