![](/images/new-backgrounds/1170357/170357555x1.webp)
Appendix A Configuration Register Information
Configuration Bit Meanings
Table | Configuration Register Bit Settings (continued) | |
|
|
|
Bit No. | Hex | Meaning |
|
|
|
Console line speed | ||
|
|
|
13 | 0x2000 | Boots default ROM software if initial boot fails |
|
|
|
14 | 0x4000 | IP broadcasts do not have network numbers |
|
|
|
15 | 0x8000 | Enables diagnostic messages and ignores NVRAM contents |
|
|
|
Bits 0–3
The lowest four bits of the processor configuration register (bits 3, 2, 1, and 0) form the boot field. Table
Table | Bits |
|
|
Boot Field | Meaning |
|
|
0 | Stays at the system bootstrap prompt (ROM monitor) on a reload or power cycle |
|
|
1 | Boots the boot helper image as a system image |
|
|
2 | Full boot process, which loads the Cisco IOS image into Flash memory |
|
|
Specifies a default filename for booting over the network from a TFTP server | |
|
|
The boot field specifies a number in binary. If you set the boot field value to 0, you must have a console port access to boot the operating system manually. Boot the operating system by entering the b command at the bootstrap prompt as follows:
> b [tftp] flash filename
Definitions of the various command options follow:
b
b filename
bflash
If you set the boot field value to a value of 2 through F, and there is a valid system boot command stored in the configuration file, the router boots the system software as directed by that value. (See Table
If there are no boot commands in the configuration file, the router attempts to boot the first file in system Flash memory. If no file is found in system Flash memory, the router attempts to netboot a default file with a name derived from the value of the boot field (for example,
If boot commands are in the configuration file, the router software processes each boot command in sequence until the process is successful or the end of the list is reached. If the end of the list is reached without a file being successfully booted, the router will retry the netboot commands up to six times if bit 13 of the configuration register is set, otherwise it will load the operating system software available
| Cisco 7500 Series Installation and Configuration Guide |
|