Cisco Systems 7500 Series manual AC-Input Power Supply LEDs Cisco 7507 and Cisco 7507-MX

Chapter 8 Troubleshooting a Cisco 7500 Series Router

Using Cisco 7500 Series System LEDs

R E V I E W D R A F T — C I S CO CO N F I D E N T I A L

Figure 8-9

DC

FAIL

AC

POWER

AC-Input Power Supply LEDs (Cisco 7507 and Cisco 7507-MX)

Captive installation screw

	D
	C
	F
	A
	IL
	A
	C
	P
	O
LEDs	W
	E
	R

Power supply front panel

AC power	I
receptacle
	O

	H1314a
On/off switch	Locking device

The DC-input power supply LEDs include the input power LED and the out fail LED. See Figure 8-10. The green input power LED is on when the input power is applied. The yellow out fail LED is normally off but flashes at power on for a lamp test.

The out fail LED goes on if the power supply shuts down for either of the following reasons:

•Power supply DC-output failure, which could be caused by loss of DC-input power (input line failure or operator turned off system power) or an actual failure in the DC-input power supply

•Power supply shutdown, initiated by the power supply because it detected an out-of-tolerance temperature or voltage condition in the power supply

Figure 8-10 DC-Input Power Supply LEDs, Cisco 7507 and Cisco 7507-MX (Same Location as AC-Input Power Supply)

OUT

INPUTFAIL

POWER

H2498

	Cisco 7500 Series Installation and Configuration Guide
8-24	OL-5008-03 B0