Cisco Systems 7500 Series manual Rack-mount the chassis as follows

Chapter 3 Installing a Cisco 7500 Series Router

Installing the Cisco 7505

R E V I E W D R A F T — C I S CO CO N F I D E N T I A L

The following guidelines are provided to ensure your safety:

–Mount this unit at the bottom of the rack if it is the only unit in the rack.

–When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest component at the bottom of the rack.

–If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in the rack.

Figure 3-4illustrates the Cisco 7505 rack-mount procedure.

Figure 3-4 Rack-Mounting the Cisco 7505

A	Rack-mount the chassis as follows:
18.312"
(46.51 cm)	1. Measure the space between the vertical
hole centerline	mounting strips on your rack. Verify that your
to hole centerline	rack conforms to the measurements
	(shown in A).
17.72" min.
(45 cm)
Mounting strip	Mounting strip
B	2. Use the four M4 x 10-mm screws provided
	to attach the ears to the sides of the chassis
	(shown in B). Use two screws per ear.

		M4 x 10-mm screws (4)
		Ears (2)
		3. To prevent injury, have someone help you
		install the chassis in the rack (shown in C).
C		Use the 10-32 x 3/8-inch screws provided to
		attach the ears to the mounting strips. Use four
		screws per ear and mounting strip. Level the
		chassis as required. Provide 2 inches of
	H2908	clearance on each side of the chassis.

10-32 x 3/8-inch screws (8)

Cisco 7500 Series Installation and Configuration Guide

3-8 OL-5008-03 B0