2-987
Catalyst 6500 Series Switch Command Reference—Release8.4
OL-6244-01
Chapter2 Catalyst 6500 Series Switch and ROM Monitor Commands show mls netflow-route
show mls netflow-route
To display summaries from NetFlow for routing in the MLS-based Catalyst6500 series switches, use the
show mls netflow-route command.
show mls netflow-route [ip | ipx]
Syntax Description
Defaults The default displays both IP and IPX MLS information.
Command Types Switch command.
Command Modes Normal.
Usage Guidelines This command is supported on Catalyst 6500 series switches configured with the Supervisor Engine 2
with Layer 3 Switching Engine II (PFC2) only.
Examples This example shows how to display summaries from NetFlow for routing:
Console> show mls netflow-route
Total packets switched = 0
Total bytes switched = 0
Software installed aging time = 0
IP flows aging time = 256 seconds
IP flows fast aging time = 0 seconds, packet threshold = 0
IP Current flow mask is Full flow
Total netflow forwarding entries = 4
Netflow Data Export version:7
Netflow Data Export disabled
Netflow Data Export port/host is not configured.
Total packets exported = 0
IPX flows aging time = 256 seconds
IPX flow mask is Destination flow
IPX max hop is 15
Console>
ip (Optional) Specifies IP MLS.
ipx (Optional) Specifies IPX MLS.