2-346
Catalyst 6500 Series Switch Command Reference—Release8.4
OL-6244-01
Chapter2 Catalyst 6500 Series Switch and ROM Monitor Commands
set igmp v3-processing
set igmp v3-processing
To explicitly enable or disable IGMP version 3 snooping, use the set igmp v3-processing command.
set igmp v3-processing {enable | disable}
Syntax Description
Defaults By default, IGMP version 3 snooping is disabled.
Command Types Switch command.
Command Modes Privileged.
Usage Guidelines IGMP version 3 is supported on Supervisor Engine2 and Supe rv isor En gine 720. Supervisor Engine 1
and Supervisor Engine 1A do not support this feature.
If IGMP version 3 processing is disabled, any previous IGMP version 3 snooping en tries are cl eare d.
These IGMP version 3 entries are relearned as IGMP version 2 (GDA-based) entries after the switch
receives an IGMP version 3 report. Any subsequent IGMP version 3 reports for other multic ast sources
or groups are also processed as IGMP version 2 reports.
When MMLS is enabled, IGMP version 3 processing works only in PIM SSM mode. If MMLS is
disabled, IGMP version 3 reports are processed as IGMP version 2 reports. IGMP version 3 processing
works independent of PIM mode when MMLS is enabled.
Examples This example shows how to enable IGMP version 3 processing:
Console> (enable) set igmp v3-processing enable
IGMP V3 processing enabled
Console> (enable)
This example shows how to disable IGMP version 3 processing:
Console> (enable) set igmp v3-processing disable
IGMP V3 processing disabled
Console> (enable)
Related Commands set igmp fastblock
show multicast v3-group
enable Enables IGMP version 3 snooping.
disable Disables IGMP version 3 snooping.