2-939
Catalyst 6500 Series Switch Command Reference—Release8.4
OL-6244-01
Chapter2 Catalyst 6500 Series Switch and ROM Monitor Commands show log
NVRAM log:
01. 1/25/2000,17:39:10: convertCiscoMIB:PreSac(0) checksum failed: 0xFFFF(0xE507
)
Module 3 Log:
Reset Count: 14
Reset History: Wed Mar 22 2000, 10:35:54
Fri Mar 17 2000, 15:36:57
Wed Mar 15 2000, 16:54:59
Tue Mar 14 2000, 16:02:19
<<<<output truncated >>>>
This example shows how to display dump log information:
Console> (enable) show log dump
Total logs: 1
Console> (enable)
Table 2 -44 describes the possibl e fields i n th e outpu t f rom the show log command.
Table2-44 show log Command Output Fields
Field Description
Network Management
Processor (ACTIVE NMP) Log Log that applies to the NMP on the supervisor engine.
Reset Count Number of times the system has reset.
Re-boot History Date and times the system has rebooted.
Bootrom Checksum Failures Number of bootrom checksum failures.
UART Failures Number of times the UART has failed.
Flash Checksum Failures Number of times the Flash Checksum has failed.
Flash Program Failures Number of times the Flash Program has failed.
Power Supply 1 Failures Number of times Power Supply 1 has failed.
Power Supply 2 Failures Number of times Power Supply 2 has failed.
Swapped to CLKA Number of times a switchover to clock A has occurred.
Swapped to CLKB Number of times a switchover to clock B has occurred.
Swapped to Processor 1 Number of times a switchover to processor 1 has occurred.
Swapped to Processor 2 Number of times a switchover to processor 2 has occurred.
DRAM Failures Number of times the DRAM has failed.
Exceptions: Exceptions log.
Last software reset by user Date of the last time the software was reset.
NVRAM log Number of times NVRAM errors have occurred.
Reset Count Number of times the system has reset.
Reset History Date and times the system has reset.
Total log Number of entries.