2-660
Catalyst 6500 Series Switch Command Reference—Release8.4
OL-6244-01
Chapter2 Catalyst 6500 Series Switch and ROM Monitor Commands
set snmp rmonmemory
set snmp rmonmemory
To set the memory usage limit in percentage, use the set snmp rmonmemory command.
set snmp rmonmemory percentage
Syntax Description
Defaults The default is 85 percent.
Command Types Switch command.
Command Modes Privileged.
Usage Guidelines This command is not supported by the NAM.
When using this command, setting the percentage value to 85 does not mean that RMON can use
85 pe rcent of memory. It means that you cannot create new RMON entries or restore entri es from the
NVRAM if the DRAM memory usage exceeds or will exceed 85 percent.
If you expect the device to run other sessions such as Telnet, a lower value should be set to the memory
limit. Otherwise, the new Telnet sessions may fail because the available memory is not enough.
Examples This example shows how to set the memory usage limit:
Console> (enable) set snmp rmonmemory 90
Console> (enable)
Related Commands show snmp rmonmemory
percentage Memory usage limit; see the “Usage Guidelines” section for additional information.