2-508
Catalyst 6500 Series Switch Command Reference—Release8.4
OL-6244-01
Chapter2 Catalyst 6500 Series Switch and ROM Monitor Commands
set port macro
To configure the QoS settings and the trusted boundary feature on the Cisco IP Phone, you must enable
Cisco Discovery Protocol (CDP) version 2 or later on the port. You need to enable CDP only for the
ciscoipphone QoS configuration; CDP does not affect the other components of the automatic voice
configuration feature.
The automatic voice configuration commands do not support channeling.
A PFC or PFC2 is not required for the ciscoipphone keyword.
A PFC or PFC2 is required for the ciscosoftphone keyword.
The ciscoipphone keyword is only supported on 10/100 and 10/100/1000 Ethernet ports.
The ciscosoftphone keyword is supported on all Ethernet ports.
To see the configuration that results in choosing the ciscodesktop, ciscorouter, or ciscoswitch keyword,
refer to the “Configuring a VoIP Network” chapter of the Catalyst 6500 Series Switch Software
Configuration Guide.
Examples This example shows how to execute the Cisco IP Phone configuration macro with an auxiliary VLAN:
Console> (enable) set port macro 3/1 ciscoipphone vlan 2 auxvlan 3
Port 3/1 enabled.
Layer 2 protocol tunneling disabled for CDP STP VTP on port(s) 3/1.
Port 3/1 vlan assignment set to static.
Spantree port fast start option set to default for ports 3/1.
Port(s) 3/1 channel mode set to off.
Warning:Connecting Layer 2 devices to a fast start port can cause
temporary spanning tree loops. Use with caution.
Spantree port 3/1 fast start enabled.
Dot1q tunnel feature disabled on port(s) 3/1.
Port(s) 3/1 trunk mode set to off.
VLAN Mod/Ports
---- -----------------------
2 2/1
3/1
16/1
AuxiliaryVlan Status Mod/Ports
------------- --------
------------------------------------------------------
3 inactive 3/1
Vlan 3 is not active.
Inline power for port 3/1 set to auto.
CDP enabled globally
CDP enabled on port 3/1.
CDP version set to v2
........
All ingress and egress QoS scheduling parameters configured on all ports.
CoS to DSCP, DSCP to COS, IP Precedence to DSCP and policed dscp maps
configured. Global QoS configured.
Port 3/1 ingress QoS configured for Cisco IP Phone.
Macro completed on port 3/1.
Console> (enable)
This example shows the warning message that appears when you do not spe cify an au xil iary V L AN:
Console> (enable) set port macro 3/1 ciscoipphone vlan 2
Warning: All inbound QoS tagging information will be lost as no auxillary
vlan was specified.