2-55
Catalyst 6500 Series Switch Command Reference—Release8.4
OL-6244-01
Chapter2 Catalyst 6500 Series Switch and ROM Monitor Commands clear lda
Usage Guidelines This command is supported only on switches configured with the Supe r visor En gine 1 wi th L aye r 3
Switching Engine WS-F6K-PFC (Policy Feature Card).
Entering the destination keyword specifies the entries matching the destination IP address specificat ion,
entering the source keyword specifies the entries matching the source IP address specification, and
entering an ip_addr_spec can specify a full IP address or a su bnet add re ss. If yo u d o not s peci fy a
keyword, it is treated as a wildcard, and all entries are displayed.
When entering the ip_addr_spec, use the full IP address or a subnet address in one of the following
formats: ip_addr, ip_addr/netmask, or ip_addr/maskbit.
If you do not enter any keywords, the LD is removed from the switch, and the LD configuration is
removed from NVRAM.
If you do not enter any keywords with the clear lda mls command, all ASLB MLS entries are cleared.
Examples This example shows how to clear the ASLB MLS entry at a specific destination address:
Console> (enable) clear lda mls destination 172.20.26.22
MLS IP entry cleared.
Console> (enable)
This example shows how to delete a VIP and port pair (VIP 10.0.0.8, port 8):
Console> (enable) clear lda vip 10.0.0.8 8
Successfully deleted vip/port pairs.
Console> (enable)
This example shows how to clear all ASLB router MAC addresses:
Console> (enable) clear lda mac all
Successfully cleared Router MAC address.
Console> (enable)
This example shows how to clear a specific ASLB router MAC address:
Console> (enable) clear lda mac 1-2-3-4-5-6
Successfully cleared Router MAC address.
Console> (enable)
Related Commands commit lda
set lda
show lda