2-423
Catalyst 6500 Series Switch Command Reference—Release8.4
OL-6244-01
Chapter2 Catalyst 6500 Series Switch and ROM Monitor Commands set mls netflow-per-interface
set mls netflow-per-interface
To enable or disable the creation of NetFlow entries on a per-VLAN basis, use the set mls
netflow-per-interface command.
set mls netflow-per-interface {enable | disable}
Syntax Description
Defaults This feature is disabled.
Command Types Switch command.
Command Modes Privileged.
Usage Guidelines Entering the set mls netflow-per-interface disable comma nd resul ts in t he creation of NetFlow entries
for all VLANs.
If you enable this feature, NetFlow entries are created both for VLANs on which bridged-flow statistics
is enabled and for VLANs on which NetFlow entry creation is enabled. Enabling this f eature on spec if ic
VLANs causes bridged-flow statistics to be enabled automatically.
For example, if you enable Layer 3 per-VLAN entry creation on VLANs 100 and 200 and at the same
time you want to enable bridged-flow statistics on VLANs 150 an d 2 50, Ne tF low entry cr eat ion and
bridged-flow statistics are both enabled on all four VLANs. To collect only bridged-flow statistics for
VLAN 150 and 250, you must disable the per-VLAN entry creation feature.
Use the set mls netflow-entry-create command to specify the VLANs for which NetFlow entry creation
can be enabled or disabled.
Related Commands se t mls netflow-entry-create
show mls
enable Enables the creation of NetFlow entries on a per-VLAN basis.
disable Disables the creation of NetFlow entries on a per-VLAN basis.