2-377
Catalyst 6500 Series Switch Command Reference—Release8.4
OL-6244-01
Chapter2 Catalyst 6500 Series Switch and ROM Monitor Commands set lacp-channel system-priority
set lacp-channel system-priority
To set the priority of the system, use the set lacp-channel system-priority command.
set lacp-channel system-priority value
Syntax Description
Defaults The default system priority value is 32768.
Command Types Switch command.
Command Modes Privileged.
Usage Guidelines LACP is supported on all Ethernet interfaces.
The set lacp-channel system-priority command is a global command; however, the priority value is
used only for the modules that are running LACP. The priority value is ignored on the modules that are
running PAgP.
Higher value numbers correspond to lower priority levels.
For differences between PAgP and LACP, refer to the “Guidelines for Port Configuration” section of the
“Configuring EtherChannel” chapter of the Catalyst 6500 Series Switch Software Configuration Guide.
Related Commands clear lacp-channel statistics
set channelprotocol
set port lacp-channel
set spantree channelcost
set spantree channelvlancost
show lacp-channel
show port lacp-channel
value Number of the priority; valid values are from 1 to 65535.