Chapter2 Catalyst 6500 Series Switch and ROM Monitor Commands show test
2-1276
Catalyst 6500 Series Switch Command Reference—Release8.4
OL-6244-01
222
To display the errors reported from the diagnostic tests, the diagnostic level, and the action that the
supervisor engine takes after a diagnostics test failure, use the show test command.
show test [mod | all]
show test diaglevel
show test diagfail-action
Syntax Description
Defaults This command has no default settings.
Command Types Switch command.
Command Modes Normal.
Usage Guidelines Only error conditions are displayed. If there are no errors, PASS is displayed in the Line Card Status
field.
Examples This example shows the error display for module 2:
Console> show test 2
Module 2 : 2-port 1000BaseX Supervisor
Network Management Processor (NMP) Status: (. = Pass, F = Fail, U = Unknown)
ROM: . Flash-EEPROM: . Ser-EEPROM: . NVRAM: . EOBC Comm: .
Line Card Firmware Status for Module 2 : PASS
Port Status :
Ports 1 2
-----------
. .
Line Card Diag Status for Module 2 (. = Pass, F = Fail, N = N/A)
Module 2
Cafe II Status :
NewLearnTest: .
IndexLearnTest: .
mod (Optional) Number of the module. If you do not specify a number, test statistics are
given for the general system as well as for the supervisor e ngine .
all (Optional) Displays errors from diagnostic tests for all modules.
diaglevel Displays the diagnostic level.
diagfail-action Displays the action that the supervisor engine takes after a diagnostics test failure.