2-392
Catalyst 6500 Series Switch Command Reference—Release8.4
OL-6244-01
Chapter2 Catalyst 6500 Series Switch and ROM Monitor Commands
set logging callhome severity
set logging callhome severity
To specify the CallHome severity level of system messages to capture, use the set logging callhome
severity command.
set logging callhome severity level
Syntax Description
Defaults The default severity level is set to 2.
Command Types Switch command.
Command Modes Privileged.
Usage Guidelines T he CallH ome f ea ture is clo sely t ied to sy slog m essages a nd the ir severity. When you set the CallHome
severity level, carefully consider what level of severity you require for both the syslog messages and the
CallHome messages.
For example, if you configure a very fine syslog severity level such as alerts (level 1), an d a co ar se
CallHome severity level such as notifications (level 5), the destinati on addresses will only receive alerts
and emergencies (levels 0 and 1) and not the remaining CallHome severity level notifications (levels 2,
3, and 4) yo u specified. To avoid this, set the CallHome severity level at the same severity level, or
higher, that you set the syslog message severity.
level Severity level of system messages to capture; severity level definitions are listed in
Table 2 -15.
Table2-13 Severity Level Definitions
Severity Level Description
0—emergencies System unus abl e
1—alerts Immediate action required
2—critical Critical condition
3—errors Error conditions
4—warnings Warning conditions
5—notifications Normal bug significant condition
6—informational Informational messages
7—debugging Debugging messages